Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Never use chemicals or aggressive detergents for cleaning.
•
No guarantee claims for the product and no liability for
any resulting personal damage or material damage will
be accepted if the product is not correctly used, if it is
overloaded or if it is not repaired in an expert way.
Installation
1) Before installing the exciter, make a test run to determine
the exciter position for the best sound reproduction.
2) To install EX-1W, remove the protective film and then
glue the exciter onto a clean, flat surface.
3) Switch off the amplifier prior to connecting the exciter.
4) Connect the cable of EX-1W to a speaker output of
the amplifier. When connecting multiple exciters to a
single output, make sure that they have the same
polarity and are not below the minimum load imped-
ance of the output.
Note: Once the exciter has been attached to a surface, use a knife
or wire, for example, to detach the exciter. Never pull the housing;
the exciter may be damaged.
Werbung
