Reality Leuchten R035-32 Bedienungsanleitung Seite 5

Commissioning
Before commissioning, please check the correct installation of the protective screens again; there is a risk of injury if they are not
installed correctly. Generally, the device may only be operated when completely assembled. Make sure that the connected supply cable
is free of damage. Never operate a device with a defective supply cable. There is a risk of electric shock. Position the device upright and
stable. When positioning the fan, make sure that curtains or other objects do not obstruct the air flow. Insert the power plug into a
properly fused power socket.
Assembly
1. Oscillating Knob
2. On / Off / Speed Knob
3. Tilt Range Knob
4. Tilt Adjustment Bolt
5. Stand Top
6. Stand Securing Screws
7. Base Washer
8. Base Thumb Screw
9. Fan Head
10. Tilt Range Screw
11. Tilt Adjustment Knob
12. Wooden Stand
13. Stand Holder
14. Base
15. Fan Head Motor
16. Coupling
a) Mount the stand to the base (14) by using base thumb screw (8) and base washer (7).
b) Position the fan head motor (15), insert the tilt adjustment bolt (4) through the square hole of the coupling (16) and the lower hole
of tube as shown within the drawing detail view. Fully tighten the tilt range screw (10) which is already located in the coupling (16). Then
fit the tilt adjustment knob (11) onto the tilt adjustment bolt (4) and (lightly) tighten.
c) Insert the tilt range knob (3) through the top hole of the coupling (16), adjust the fan head to the desired position and firmly tighten
tilt range screw (10) and the tilt adjustment knob (11).
Technical Information
Power Rating: 35 W
Service Value: 1,03 (m³/min.)/W
Fan Sound Power Level: 51,2 // 55,6 // 61,2 dB(A)
Max. Fan Flow Rate: 36,13 m³/min
Stand By Power Consumption: 0 W
Max. Air Velocity: 1,3 // 1,5 // 1,8 m/s