Hach CDx440sc Bedienungsanleitung Seite 6

1. Disconnect the equipment from its power source to verify that it is or is not the source of the
interference.
2. If the equipment is connected to the same outlet as the device experiencing interference, connect
the equipment to a different outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
2.2 Icons used in illustrations
Manufacturer
User supplied parts
supplied parts
2.3 Product overview
The CDx440sc gateway is not certified for hazardous location installation or use. Use of the CDx440sc gateway in
a hazardous location could result in death or serious injury.
The CDx440sc gateway is the interface that lets the GS1440 or GS2440EX sensor connect to an SC
Controller. Figure 1 gives an overview of the gateway assembly.
Figure 1 Product overview
1 CDx440sc gateway
2 Mounting bracket
3 Pipe clamp slots (4x)
4 Mounting holes (4x)
2.4 Product components
Make sure that all components have been received. Refer to
damaged, contact the manufacturer or a sales representative immediately.
6 English
Do not use tools Use fingers only
W A R N I N G
5 Cable strain relief for RS-232 sensor cable
6 Cable strain relief for Power/4–20mA sensor cable
7 Digital SC connector for digital extension cable
Figure
Look
2. If any items are missing or