Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
4
5
A
A
6
This towbar is designed to assembly in following car:
KIA K2500 / 2700 / FRONTIERS, loading platform, produced since
1998, catalogue no. T 23 and is prepared to tow trailers max total weight
1400kg and max vertical load 75kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
A
5
4
1
3
From manufacturer
1. The main bar of the towbar put outside of the chassis members (see fig.
no. 2). Squeeze up main bar to chassis members and drill holes pos. A
straight through using bit ø12,5mm.
2. Made holes drill again (only from inside) by bit ø22,5mm, put distance
6
sleeves (pos. 5), put fish-plate (pos. 4) and twist on using bolts
M12x90mm (pos. 6).
A
ATTENTION!
At the turn of the year 2004/2005 manufacturer has change the
construction. All montage points are originally prepared. You must use
only bolts M12x90mm (without distance sleeves pos.5 and fish-plates
pos. 4, no drill).
3. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x100mm
(pos. 4) from equipment.
7
4. Tighten all bolts according to the torque shown in the table.
11
5. Connect electric wires of 7-pole socket according to the instruction of
the car. (Recommend to make at authorized service station)
6. Complete paint layer damaged during installation.
2
A-drill straight
through
Fig. 2 Main bar installation
głównej
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
Fitting instructions
Out side of the
chassis members
Rear part of the car
NOTE
Werbung
