Juskys 24861 Gebrauchs- Und Montageanleitung Seite 13

CAUTION
Risk of injury due to improper use.
►Use the product in accordance with its in-
tended use, see chapter „1.2 Use as inten-
ded" on page 10.
Note: Adjust the height with a second person.
Tilt the basketball hoop, stabilised by a second
person, slightly backwards.
Loosen the cap nut and remove the screw.
Loosen the locking screw until the support rod of
the basket frame can be adjusted.
Set the desired height ().
Put the screw back into the hole.
Put the spring washer on the end of the screw and
tighten the cap nut with the spanner.
Tighten the locking screw.
The height has been set.
7. Disassembly
►Disassemble the product in reverse order of as-
sembly, see chapter „14. Assembly" on page
34.
8. Store
ATTENTION
Damage to the product due to incorrect
storage.
►Store the product assembled and upright
or disassembled afterwards in a dark,
cool, dry and well-ventilated place.
►Protect the product from dust and mo-
isture.
►Do not place any objects on the pro-
duct because of deformations that
may occur.
►The storage location must be frost-free
when the product is assembled and
the base is lled with water.
9. Maintenance and schedule
9.1 Cleaning
ATTENTION
Damage caused by incorrect cleaning
agents.
►Check the compatibility of the clea-
ning agent with the surface on an in-
conspicuous area.
►Do not use any organic solvents, boiling
water, strong acids or alkaline cleaning
agents for cleaning.
►Remove dust and light dirt with a damp cloth or a
soft brush.
►Use a mild, non-fammable and ood-sae clea-
ning agent or a cloth dampened with water for
heavy soiling.Regular maintenance increases
the safety and longevity of your product.
9.2 Maintenance plan
Before each use
Condition
►Check the overall condition of the product.
Attachment parts
►Check whether attachment parts have be-
come loose or distorted.
10. Repairing
ATTENTION
Damage due to improper repair
Self-locking screws and other attachments
lose their effectiveness if they are replaced
without screw locking again.
►Only use spare parts approved by the
manufacturer or original ones.
►Only have repairs carried out by quali-
ed personnel.
EN
13