Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CLEANING AND MAINTENANCE
The outside of the device should be cleaned periodically to remove contaminants such as dust etc.
1
Disconnect the device from power and allow it to cool before cleaning.
2
Clean the surface with a soft lint-free and moistened cloth. Never use alcohol or solvents as these may
damage the surface. Make sure that no liquids can enter the device.
3
The device must be dry before reapplying power.
There are no serviceable parts inside. Do not open the housing. Do not try to repair the device by yourself as
this may result in damage. Maintenance and service operations are only to be carried out by authorized
dealers. Should you need any spare parts, please use genuine parts. Should you have further questions,
please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption/meter:
Cutting unit:
LEDs/unit:
Protection rating:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
Dimensions:
Max. length:
Weight/piece:
Weight/roll:
Please note: Every information is subject to change without prior notice. 13.12.2018 ©
230 V AC, 50 Hz
16 W/m (RGB)
6 W/m (red, yellow)
16 W/m (green, cold white, warm white)
20 W/m (blue)
100 cm
72 x SMD 5050 (RGB, red, yellow, green, blue)
120 X SMD 2835 (cold white, warm white)
IP44
:
45° C
a
(steady state):
50° C
C
0.5 m
0.1 m
Ø 12 x 20 mm
100 m
260 g
13 kg
14/16
00121255, Version 1.0
Werbung
