Changing The Bulb; Disposal Instructions - Pontec FLS 30 Gebrauchsanweisung

GB

Changing the bulb

1. Disconnect the light or the safety transformer
from the mains power and secure it from
being switched on unintentionally.
2. Press the bulb out of the rock from the rear
and dry it off.
3. Unscrew the screw ring (5) from the bulb
housing (1).
4. Remove the protective glass (4) and the ring
seal (3).
5. Take bulb (2) out of its mounting and replace
it.
Caution! Do not touch the new bulb (2)
directly with your hand as this
significantly reduces the service life of
the bulb. Use a piece of paper or a soft
cloth to replace the bulb.
6. The power consumption on the bulb and that
on the nameplate must agree.
7. Replace the ring seal (3) and the protective
glass (4).
8. Replace the screw ring by screwing it (5) onto
the bulb housing (1).
9. Replace the bulb in the polyresin rock.
Cleaning
1. Disconnect the light or the safety transformer from the mains power and secure it
from being switched on unintentionally.
2. Clean the halogen spotlight with warm water without cleaning agents using a soft
brush or cloth. Ensure that no moisture gets into the bulb housing.
Storage/Wintering
If frost is expected, then you must deinstall the halogen spotlight. Thoroughly clean
the device (see "Cleaning"). Check the rock lights for damages. Store the rock lights
in a dry and frost-free location. Children must not have access to the storage location.

Disposal instructions

Dispose of your device in an environmentally responsible manner. Obtain information
concerning disposal from your local garbage disposal authority.
512-05 FLS 30 Pontec.p65
Directions for use
9
GB
5
4
3
2
19.07.2005, 09:59
1
9