Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Installation
Installing the flush-mount cabinet
Note: The flush-mount cabinet must be submerged into the wall at least 130 mm. If
the cabinet only is set to the first stop frame in the wall, a wall-flush installation is
not possible!
1. Dimension the hole in the wall according to the dimensions of the flush-mount cabi-
net.
2. Install the cabinet in the wall.
3. Route the water supply lines centrally in the cabinet from below.
4. Connect the water supply lines with the pre-assembled manifolds.
5. If necessary, fill open spaces between wall and cabinet with polyurethane foam or
other suitable heat-resistant filler.
6. Install the cabinet panels once both DSX are installed and flooring and wall plaster-
ing has been completed. Snap the cover at the frame bottom edge first, than close
it.
Installing connection pieces
Note: Fasten the screw nuts with caution, to avoid damage to the valves or the
piping system.
1. The two ½ inch screw-in nipples and the ½ inch seals must be screwed into the
½ inch union nuts of the hot-water and cold-water connectors.
2. Remove the two ½ inch caps of the side outlets of the hot-water and cold-water
connectors and mount them onto the open end of the screw-in nipples.
3. Screw the ½ inch side outlets of the hot-water and cold-water connectors with the
½ inch union nuts of the preassembled manifolds, together with the ½ inch seals.
4. Repeat the steps 1 - 3 with the connecting pieces of the second appliance.
The hot-water and cold-water connectors must then be screwed into the
nut of the appliance, together with the
Note until installation: put the strainer into the cold water connection!
Installing DSX
Install the DSX as described in the installing instructions of the appliance (chapter:
"Installing the appliance").
13
2
1
3
/
inch seals.
8
CLAGE
/
inch union
3
8
Werbung
