Miscea CLASSIC Wartungsanleitung Seite 4

2. USING TUBECLEANSE
Install TubeCleanse solution on the left side of
the Soapbox.
Press the blue LED button on the waterbox to
activate priming mode. The blue LED light will
start blinking.
Activate the soap and "-" sectors at the same
time. After 45 seconds the pump will
automatically stop. Repeat this 4 times.
After the 4th time, leave the TubeCleanse
solution in the tube for 5 minutes.
After 5 minutes, activate the soap and "-" sectors
at the same time. After 45 seconds the pump will
automatically stop.
Remove the TubeCleanse solution from the left
side of the Soapbox and install it on the right side
of the Soapbox. Activate the disinfectant and "+"
sectors at the same time. After 45 seconds the
pump will automatically stop. Repeat this 4
times.
After the 4th time, leave the TubeCleanse
solution in the tube for 5 minutes. Activate the
disinfectant and "+" sectors at the same time.
After 45 seconds the pump will automatically
stop.
3