Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
- WARNING:
Do not touch them during or immediately after use.
-
Follow the drying instructions for the fabrics you wish to dry.
-
Never cover the ventilation outlets or insert objects in them.
Box content
-
IronHero 1200 Mannequin Dry drying and ironing mannequin
-
2 telescopic rods
-
Support rod
-
Y-shaped bracket
-
Hanger
-
Non-drip protector
-
Balloon for top garments
-
Balloon for bottom garments
-
4 counterweight clamps
-
Instruction manual
3. OPERATION
Instructions on the control panel
Power button: press this button to turn the device on or off.
1.
2.
Timer increase/decrease button: you can set the timer to 15, 30, 60, 90, 130, or 180
minutes. Press the corresponding button to adjust the timer. A countdown will start and
last for the duration of the set time.
3.
Temperature setting button: you can adjust the temperature by pressing ( ) and select
between room temperature (
is set to HIGH.
Air-speed setting button: press this button to select LOW or HIGH air-speed level.
4.
Assembly
The device includes two telescopic rods that can be used at the same time thanks to the
Y-shaped bracket for bottom or heavy garments, or you can use a single rod for lighter
garments such as shirts.
Assembly for top garments
1.
Insert the left and right hangers into the collar section. Fig. 3
2.
Loosen the height-adjustment clip and pull the upper rod (a) to adjust the height. Once
hot surface. The motor unit and telescopic rod heat up during operation.
), 50 °C, and 60°C if speed is set to LOW and 70 °C if speed
IRONHERO 1200 MANNEQUIN DRY
ENGLISH
37
Werbung
