Hama 00178334 Bedienungsanleitung Seite 3

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions
or to draw your attention to specific hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Safety Notes
• Use the product for its intended purpose only.
• Protect the product from dirt, moisture and over-
heating, and only use it in a dry environment.
• When using this product, observe the applicable
local traffic laws and regulations.
• Do not drop the product and do not expose it to
any major shocks.
• Keep the packaging material out of the reach of
children due to the risk of suffocation.
• Dispose of packaging material immediately accord-
ing to locally applicable regulations.
• Do not modify the product in any way. Doing so
voids the warranty.
2
3. Montage
Warning
• Take care that components such as airbags,
safety areas, controls, instruments, etc. and
visibility are not blocked or restricted.
• Do not allow yourself to be distracted by the
product, for example when driving a vehicle
or operating sports equipment. Always pay
attention to the surrounding traffic and your
environment.
Note
Never apply force when using the product or
during installation.
3.1 Attaching the holder
• Remove the protective film from the suction cup
and position it on a clean and flat surface (e.g.
window pane).
• If the suction cup holder is to be attached to
a rough or uneven surface, an adapter plate is
optionally available.
• Turn the base of the holder (1) clockwise to attach
the suction cup.
• Open the clamping device (2) to position the
carrying arm.
• Close the clamping device to lock this position.
• To detach the suction cup from the surface, turn
the base of the holder anticlockwise. Then gently
pull the flap to completely release the suction
cup. (3)
3.2 Mounting the holder
• Set the recess or recesses of the holder onto the
bracket.
• Move the holder up or down until it clicks into
place or is seated firmly.