Werbung
Verfügbare Sprachen
Verfügbare Sprachen
is tilted forward. Do not forget to set the control knob to the "0" position, otherwise the motor will switch on
automatically when the handle is placed back on the bulges of the lid with loading shaft.
• During operation, place the device on a flat, stable surface, in a place where it cannot fall over.
• The device is equipped with anti-slip feet
on a flat surface (such as a kitchen worktop, table, etc.), so it cannot slip or tip over due to vibrations when in
use.
• The device is intended for making juice of soft fruits and vegetables.
• The device is not intended for:
o Hard components of food, such as: nuts, kernels, large grains or stems.
o Materials that are not food.
• WARNING! Cutting danger. The rasps of the grate filter net
on the device when operating the device and secure the lid by placing the handle
2
rasps of the device can cause serious injuries to body parts!
• Fill the ingredients in the loading shaft of the lid
processing them. Allow hot ingredients to cool down before processing them (maximum temperature of 60 °C)
• Use only the food presser
• WARNING! Use only the food presser to push the fruit or vegetables through the loading shaft. Do not
use any body parts or kitchen utensils to push the fruit or vegetables through the loading shaft, this could
damage the device or cause injuries.
is equipped with a pulp / mash overflow on top and a juice outlet on the bottom. Place the
• The middle ring
4
pulp / mash container
6
the juice outlet.
• Turn the control knob
o Speed position "1": is for weak grating of fruit and vegetables.
o Speed position "2": is for strong grating of fruit and vegetables.
• WARNING! Once the juice container is filled to the 500 ml indicator or after 3 juice operations of 1
minute, turn the control knob
3x operation, allow the device to cool down for 15 minutes to prevent the motor from overheating and getting
damaged.
• Caution: Raisins are not suitable for juicing as they contain too little juice. Rhubarb or other fibrous vegetables/
fruits are not suitable for juicing as the fibres block the grater filter net
• To avoid fruit or vegetables becoming blocked in the loading shaft
on. Should fruit or vegetable pieces become stuck in the loading shaft, and they cannot be promptly fed through
with the food presser
1
further instructions at "cleaning and maintenance"
• To avoid blockage of the juice outlet, regularly clean the juice outlet and pulp / mash outlet after each use.
• WARNING! Wait until the device is stopped, make sure the rotating parts have reached standstill,
remove the power plug from the mains power.
• Release the handle
5
off the middle ring
with loading shaft
2
or vegetable mash out of the grate filter net into the pulp / mash container
juicer base
and scoop the fruit pulp or vegetable mash out of the middle ring into the pulp / mash container
7
, empty the pulp / puree container in the trash or on a compost heap. Shake the collected juice from the juice
6
container
into a glass or cup and enjoy fresh homemade juice.
10
4) CLEANING AND MAINTENANCE
4) CLEANING AND MAINTENANCE
• Clean the device after each use, as it comes into direct contact with food.
• Remove the plug from the mains power and allow the device to cool down fully (± 15 minutes).
• Never immerse the juicer base
• Never steam clean the device.
• Clean the juicer base
• Clean the food presser
and juice container
6
10
other liquid. After cleaning rinse them with tap water.
• WARNING! Cutting danger. It is advised to clean the grate filter net
the grate filter net
are very sharp!
3
. These ensure that the device is placed more stably and securely
9
to gently push the fruit or vegetables through the loading shaft.
1
under the pulp/mash overflow of the middle ring. Place the juice container (10) under
counter clockwise to speed position "1" or speed position "2".
8
clockwise to speed position "O" to allow it to cool down for 1 minute. After
8
, switch off the device and remove the power plug from the mains power. Follow the
from the bulges of the lid with loading shaft
. Take the grate filter net
4
in water or any other liquid.
7
and power cable with a damp cloth.
7
, lid with loading shaft
1
in warm water and washing-up liquid. Do not clean the juicer base
are very sharp. Place the lid with loading shaft
3
. Cut large ingredients into pieces of maximum 5 cm before
2
.
3
, only fill it when the device is switched
2
and tilt the handle forward. Take the lid
2
off the juicer base
3
, grate filter net
, middle ring
2
3
under running water, as the rasps of
3
over the lid bulges. The
5
. Scoop the fruit pulp
7
. Take the middle ring (4) off the
6
, pulp / mash container
4
in water or any
7
EN 05
Werbung
