Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USER INSTRUCTIONS
TO PLACE THE INSTRUMENT ON THE STAND
A FIRST ADJUST THE STAND
4 Ensure that the knurled knob under the cone is
4
tightened.
5 Loosen the sleeve grip
6 Pull up the extension including the cone until
6
almost entirely extended 6a and re-tighten the
6
sleeve grip 6b
B PLACE THE INSTRUMENT ON THE HOLDER
7 Position the bell of the instrument on the cone
7
support while continuing to hold the instrument
7
firmly with one hand
8 Loosen the knurled knob with the other hand and
8
continue to hold this too
9 Now slowly move the cone support plus instrument
9
down until...
10 ... the rubber ball fits comfortably in the bell funnel
NOTE: the cone support takes the weight of the
NOTE:
trombone whereas the rubber ball is merely to
NOTE:
aid positioning
11 Fix the position by tightening the knurled knob
C TO ADJUST THE HEIGHT OF THE STAND
12 If the trombone slide is too far from the ground, we
12
recommend lowering the extension slightly.
13 To do this take hold of the extension under the
13
cone...
14 Release the sleeve grip with the other hand...
15 Allow the extension to retract slowly...
16 ...and retighten the sleeve grip
You will now have a lower centre of gravity and a
more stable stand.
MAINTENANCE, CARE
- be aware of the danger of pinching or knocking
-
when maintaining the stand.
- to clean the stand use a slightly damp cloth and
-
non-abrasive cleaning agent.
FAULTS (F) & CORRECTION (C)
F: Stand wobbles
C: Check the ground, tighten the pedestal knob 2
C: If possible, retract the extension slightly C12-16
F: Instrument wobbles
C: Optimise the position of the instrument B7-11
SPECIFICATIONS
Extension/screws: steel - powder coated/
zinc plated
Material
Pedestal, sleeve grip: zinc casting
Floor protectors, rubber ball: TPE
Clamps, guides, grips: PA
Capacity
Base trombone
Dimension Footprint: 560 mm, height: 700-1160 mm
Pack size 680 x ø136 mm
Weight
2,1 kg
Werbung
