Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Risk of battery leaking
In the event of a battery leak, immediately re-
move it from the device to prevent damage!
Avoid contact with the skin, eyes and mucous
membranes! In the event of contact with bat-
tery acid, thoroughly flush the affected area
with plenty of clean water and seek immediate
medical attention!
Avoid extreme environmental conditions and
temperatures, which could affect batteries, e.g.
above radiators/in direct sunlight.
Remove the batteries from the device if they
have not been used for a long period!
Risk of property damage
Only use the specified battery type!
When inserting the battery ensure the correct
polarity! This is shown in the battery compart-
ment!
If necessary, clean the battery- and product
contacts before inserting them.
Promptly remove dead batteries from the
product!
Before installation
The integrated solar cell
solar radiation into electrical energy and stores it in
the Ni-MH rechargeable battery. The light switches
itself on when it starts to get dark. The integrated
LED is an energy-saving illuminant with a very long
life. The light duration depends on the amount of
sunlight, the angle of light on the solar panel and
the temperature (the battery capacity is tempera-
ture-dependent). The ideal situation is a vertical an-
gle. Given the best conditions, a burn time of
approx. 8 hours can be achieved. The rechargea-
ble battery will only achieve its maximum capacity
after several charging and discharging cycles.
Installation
Insert the lower stake
Now guide it into the decorative trim
Fig. A).
6
GB/IE/NI
of the product converts
3
into the top stake
5
2
(see
1
Push the stake of the into the ground (lawn,
flower bed, etc.).
Note: Ensure the product is stable. Do not use
force when assembling or setting up the prod-
uct, e.g. hammer blows. This will damage the
product.
Note: For the best results, put the light in a
place where the solar cell
rect sunlight for as long as possible. Do not put
the light under bushes, trees, canopies etc. as
this reduces the incidence of incoming sunlight.
Position the lamp in such a way that the solar
cell is not covered or in the shade.
Note: Make sure the solar cell is not im-
pacted by other light sources, e.g. yard- or
street lighting, or the light will not switch on at
twilight.
Operation
Switching the light on and off
Set the ON / OFF switch
of the solar housing
switch the light on or off.
Note: If the ON / OFF switch is set to ON,
the light will automatically switch on at dusk.
The RGB LED at the end of the top stake
will then produce a colour flow lighting effect
which flows from the fibre optics of the decora-
tive trim
to the tips of the buttlerfly's wings.
1
Switch the light off (OFF position) if the light
will be in the dark for extended periods (e.g.
when transporting with the battery inserted).
Setting the switch to OFF will disable the light and
charging.
Replacing the battery
(Fig. B + C)
The battery is a wear part and should be replaced
.
regularly (about every 1–2 years).
Since in central Europe the product is unable to ab-
sorb sufficient energy during the winter months due
is exposed to di-
3
on the underside
7
to ON or OFF to
4
2
Werbung
Inhaltsverzeichnis
