Hama 00096016 Bedienungsanleitung Seite 5

• Be careful not to bend the LED band. This can
cause damage to the band.
• Do not connect the product to other lighting
systems.
• Do not open the device or continue to operate it
if it becomes damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
qualified experts.
• Keep this product, as all electrical products, out
of the reach of children!
• Dispose of packaging material immediately
according to locally applicable regulations.
• Do not modify the product in any way. Doing so
voids the warranty.
Warning – Batteries
• Immediately remove and dispose of dead
batteries from the product.
• Only use batteries (or rechargeable batteries)
that match the specified type.
• When inserting batteries, note the correct
polarity (+ and - markings) and insert the
batteries accordingly. Failure to do so could
result in the batteries leaking or exploding.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or
allow them to enter the environment. They
can contain toxic, environmentally unfriendly
heavy metals.
• Remove the batteries from the product if you
will not be using it for an extended period,
unless it is being kept ready for emergencies.
4. Operation
• Connect the USB cable (25) to the control unit of
the LED band.
• Then connect the USB connector on the USB
cable (25) to the USB port on your television.
• Alternatively, you can also connect the USB
connector to a USB charger or to another
terminal device with USB port.
Note - Connecting to terminal devices
• Before connecting to a terminal device, check
whether the power output of your terminal
device can supply sufficient power for the
LED band.
• For more information, please refer to the
operating instructions of your terminal device.
If necessary, ask the relevant manufacturer's
support centre for the information you need.
• Remove the protection foil from the rear of the
LED band to fasten it to your television, wall, etc.
using the self-adhesive strip on the rear.
Note
• Ensure that you do not cover any
connections, ventilation holes or similar when
attaching the product.
• Remove the contact breaker between the battery
and the contacts before operating the remote
control.
• Press the ON button (19) / OFF button (13) on the
remote control to switch the LED band on/off.
Note
• Ensure that there are no objects that could
block or interfere with the signal between the
IR sensor and the control device.
• To replace the battery of the remote control,
open the battery compartment on the back of
the remote control and replace the battery with a
new one of type CR2025. Ensure that the polarity
is correct.
3