Trouble Shooting - Merax Ex306071Aaa Benutzerhandbuch

9. TROUBLE SHOOTING

If the following problems occur with the dehumidifier, please check the machine, and solve the
problem as follows.
Trouble
Hot air
The unit does not run
Dehumidification
does not work
No Wind
Noisy operation
NOTE:
Do not repair or disassemble the machine yourself. Unqualified repairs may cause damage to the
user or his property.
If you encounter a problem that is not listed on the form or if the recommended solution is invalid,
please contact a professional service agency.
1. Information on servicing
1) Checks to the area
Prior to beginning work on systems containing flammable refrigerants, safety checks are necessary
to ensure that the risk of ignition is minimized. For repair to the refrigerating system, the following
precautions shall be complied with prior to conducting work on the system.
Cause
✓ Cold air inside dehumidifier goes
through compressor
temperature and absorb heat and
changed to hot air.
✓ Unit is not connected to the mains.
✓ Water tank is full.
✓ Water tank incorrectly installed.
✓ Low room relative humidity and
temperature.
✓ The air outlet or intake is blocked.
✓ Air filter is blocked.
✓ Unit is tilted or unstable.
✓ Filter is blocked.
with high
➢ This is not a failure
➢ Connect the unit to the mains.
➢ Empty the water tank, install the water
tank correctly.
➢ In the dry season, the dehumidification
capacity of the dehumidifier will be
reduced.
➢ clear the things that block the air inlet
outlet.
➢ Clean the filter as described in this
manual.
➢ Put the unit upright on a flat and stable
surface.
➢ Clean the filter as described in this
manual.
Solution