North Light EL280HF WH Bedienungsanleitung

Outdoor Wall Light
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for any
errors in text or images and any necessary changes made to
technical data. If you have any questions concerning technical
problems please contact our Customer Services.
Safety
• Warning: All light fittings must be installed in accordance
with current safety regulations to prevent life-threatening
accidents.
• The installation of this light fitting should only be performed
by someone with a good knowledge of electrical wiring.
• If in doubt, contact a qualified electrician.
• Follow the instructions carefully and keep them for future
reference.
Disposal
This product should be disposed of in accordance with local
regulations. If you are unsure how to proceed, contact your
local council.
Specifications
Voltage 230 V AC, 50 Hz
Bulb Max 60 W, E27 (sold separately)
Ingress protection IP44
36 cm
Height
GREAT BRITAIN • CUSTOMER SERVICE
tel. 0845 300 9799 e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk
Art.no 36-5831-1
36-5831-2
Description
4
3
2
7
1
1. Terminal block cover
2. Earth terminal
3. Terminal block
4. Wall plate
5. Lamp housing
6. Lamp housing retaining screw
7. Cover retaining screw
Model EL280HF WH (white)
EL280HF BK (black)
Installation
Warning: Always turn the power
off at the distribution box before
installation (main power switch/
5
circuit breaker set to OFF, or fuse
completely disconnected).
1. Loosen the lamp housing's
retaining screw (7). Flip up
the housing (5) from the bottom to
remove it from the wall plate (4).
2. Remove the cover's retaining
screw (1) to access the terminal
block. Remove the cover.
3. Puncture the rubber grommet
in the wall plate and thread
the power lead through.
4. Depending on wall type, you can
either screw the wall plate directly
6 onto the wall or mark out and drill
mounting holes and use plugs for
mounting. Note: The wall plate
should be mounted with the light
fixture in the upright position.
5. Connect the power lead to
the terminal block (3) as shown in
the illustration.
- Brown or black (live) connects
to the terminal marked L.
- Blue (neutral) connects to
the terminal marked N.
- Yellow-green (earth) connects to the earth terminal
marked ( ) (wind the earth lead clockwise around
the earth terminal (2) and tighten the screw).
6. Screw the terminal block cover back on.
7. Screw in a light bulb (max 60 W, E27) (sold separately).
8. Refit the lamp housing back onto the wall plate (begin
by hooking the top of the housing on first and then flip
it down over the wall plate to ensure a proper fit). Insert
the housing's retaining screw (6) and tighten.
9. Turn the power back on.
ENGLISH