Herunterladen Diese Seite drucken

Televes 593001 Bedienungsanleitung Seite 5

Rauschgenerator

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

A device designed to carry out attenuation and
flatness testing in F.I. satellite installations with no
entry signal, connected to a Televés field strength
meter.
Equipped with a thumbwheel allowing the output
level to be varied by 10 ± 2 dB in 6 steps.
1
N ormal signal output. Electrical connection
from installation to power the simulator.
2
Output attenuated by 30 dB compared to
output obtained in 1. If the attenuated output
is used, the main output must be charged.
3
Thumbwheel to vary the output level in both
connectors by 10 ± 2 dB.
4
LED indicator
5
Connector to provide external power to the
simulator using the DC adaptor.
Dispositivo progettato per effettuare prove di atte-
nuazione e linearità su impianti in SMATV e CATV,
usato congiuntamente con un misuratore di cam-
po di Televés.
Dispone di un commutatore rotativo che permette
di variare il livello di uscita in 10 ± 2 dB in 6 passi.
1
Uscita dei segnale normale. Ingresso di ali-
mentazione proveniente dal cavo coassiale
per l'alimentazione del simulatore.
2
Uscita attenuata 30dB rispetto a quella che si
ottiene in 1. Quando viene utilizzata l´uscita
attenuata, l´uscita principale deve essere
chiusa con un carico.
3
Commutatore rotativo che permette di varia-
re 10 ± 2 dB il livello di uscita in entrambi i
connettori.
4
Led di accensione.
5
Connettore per alimentare esternamente il
simulatore mediante adattatore DC.
Ein Messmittel zum Testen von Dämpfungen und
Schräglage in Satellitenempfangsanlagen, ohne
dass ein Eingangssignal anliegt; in Verbindung mit
einem Televes Messgerät.
Mit einem Drehschalter kann der Ausgangspegel
in 6 Stufen auf 10dB (± 2dB) eingestellt werden.
Anschlüsse:
1
Normaler
Signalausgang.
Verbindung um den Simulator von der
Anlage aus fern zu speisen.
2
Ausgangssignal
um
30dB
gegenüber dem Signal an Ausgang 1. Wenn
dieser Ausgang benutzt wird, muss der
normale Ausgang abgeschlossen werden.
3
Drehschalter
um
die
Ausgangsleistung
zwischen 0 und 10dB einzustellen.
4
LED Anzeige.
5
Anschluss
für
die
Spannungsversorgung
mitgelieferten DC Adapter.
5
Elektrische
abgesenkt
externe
über
den

Werbung

loading

Diese Anleitung auch für:

Rg3000