ACU-RITE DRO 100 Installationsanleitung Seite 13

5.6 Connecting a touch probe
The following touch probe can be connected to
a DRO 30x product:
HEIDENHAIN KT 130 edge finder
Further information:
Remove and save the dust protection caps
Route the cables depending on the mounting variant
"Assembly", Page 10
Further information:
Connect the touch probe tightly to connection X10
Further information: "Product overview", Page 12
If the cable connectors include mounting screws, do
not overtighten them
Pin layout of X10
Further information: "Q", Page 128
ACU-RITE | DRO 100, DRO 203, DRO 300 | Installation Instructions | 01/2018
"Accessories", Page 9
5.7 Connecting the line voltage
WARNING
Risk of electric shock!
Improper grounding of electrical devices may result in
serious personal injury or death by electric shock.
Always use 3-wire power cables
Make sure the ground wire is correctly connected to
the ground of the building's electrical installations
WARNING
Fire hazard from the use of power cables that do not
meet the national requirements of the respective
country in which the product is mounted.
Improper grounding of electrical devices may result in
serious personal injury or death by electric shock.
Use only a power cable that meets at least the
national requirements of the respective country in
which the product is mounted
Use a power cable that meets the requirements to
connect the power connection to a 3-wire grounded
power outlet
Further information: "Product overview", Page 12
Pin layout of the power connection
"R", Page 128
Further information:
13