Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en |
28 | VAS 6430 | Product description
5.5.5
Dismantling adjustment device 6430/1
i
Refer to Installation/erection
5.5.6
Installation
Other items
The following additional items are required for installing
the stationary base frame 6430/7:
R
Hammer drill
R
Concrete drill bit (dia. 6, dia. 8)
R
Spirit level (1 mm accuracy)
R
Measuring tape
R
Set of Allen keys
R
10 mm box wrench
!
As they are fixed to the workshop floor, the rails
represent a greater tripping hazard.
1. Align the base frame as specified.
2. Pre-drill the left side (refer to hole pattern) to dia. 6.
3. Enlarge the pre-drilled side to dia. 8.
4. Fit the connectors as specified by the manufacturer.
5. Screw on the rail hand-tight.
6. Slide the base frame to the first drilling location.
7. Perform items 2–5 for the right side.
Check freedom of movement.
8. Perform diagonal and vertical levelling until the
tolerance range is attained.
i
When pre-drilling, the base frame has to be moved to
the corresponding drilling location.
Fig. 22: Stationary base frame
Fig. 23:
Stationary base frame with rails
1 Wedge
|
1 690 386 012
2013-09-24
i
Further shims may be required under the rails.
Fig. 24:
Levelling
Fig. 25:
Stationary base frame with stand
1 End stop
Re-positioning end stop
1. Remove the cap.
2. Screw out the cheese head bolt.
3. Screw in the cheese head bolt with packing plate.
Fig. 26:
Stationary base frame with cross laser
¶
Centrally align the stationary base frame with the
cross laser.
Beissbarth GmbH
Werbung
