Beissbarth VAS 6430 Originalbetriebsanleitung Seite 25

Fig. 16: Clamping pieces
1 Rear clamping piece
2 Front clamping piece
i
Make sure the clamping pieces do not rest on the
adjustment shaft.
1. Tighten the bolts.
2. Slide down the clamping pieces on the front of the
frame and tighten.
5.4.3 Fitting calibration board handles
1. Position the calibration board on the side guide
bars.
2. Swivel the first slot block into position and tighten
the bolt slightly.
Beissbarth GmbH
Product description | VAS 6430 | 25 | en
Fig. 17: Tightening slot block
1 Guide bar
1. Swivel the second slot block into position and
tighten the bolt slightly.
2. If necessary, slide the handles into the required
position and tighten the bolts.
3. Repeat the procedure on the second side.
i
Take care not to damage the calibration board on
fitting.
Fig. 18: Height-adjustable handle
Handles and accessories (set)
|
1 690 386 012 2013-09-24