Hesperide 165058 Bedienungsanleitung Seite 6

CARE INSTRUCTIONS
1/ Your product
Properties
Part of the frame is made up of aluminium parts (for its lightness) and epoxy painted
steel parts (for its sturdiness).
Aluminium is a light, resistant material that doesn't rust.
Epoxy steel is a steel covered with a protective paint against rust.
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between
the different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between
the different assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little
geometric differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface
treatment is carried out individually, before assembly. These metallic elements cannot be
free from appearance irregularities coming both from the surface treatment process and
assembly operations. The final appearance of the product is therefore directly linked to
these possible irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to
notice that some threads are not cut after the break point of the seam. There is no risk of
the seam becoming undone. Cut this thread with a simple pair of scissors.
Size of the cloth
The size indicated always corresponds to the size flat of the cloth. The useful size is slightly
less, due to the angle given to the cloth by the parasol.
2/ Precautions for use
We cannot guarantee the good behavior of this product under difficult atmospheric conditions.
We recommend closing the umbrella during strong winds, thunderstorms, hailstorms or heavy
rain. In these conditions, it is recommended not to be under or near the parasol.
After each significant bad weather we invite you to check the general condition and the solidity
of the structure before use. Attention, danger of overturning in the event of a gust of wind.
Fold the parasol in case of wind and strap it.
It is recommended not to leave an open umbrella unattended.
The accumulation of water and / or dead leaves on the canvas contributes to its degradation
and to that of the structure: make sure to clean it regularly and to eliminate any pockets
of water.
Do not hang products on the frame.
It is necessary to fix the parasol in a stable, weighted base and on a flat surface.
We do not recommend mounting a light fixture or other heat source on the structure in
contact with or near the fabric.
Watch out for knives and other sharp objects being handled nearby. Also watch out for
cigarette burns and other sources of heat.