Current Tetra Select TX Rigid Light Bar Installationsanleitung Seite 3

Select TX Rigid Light Bar
1 Clean the mounting
surface.
Screw to fix the bar.
4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. This Class [A] RFLD complies with the Canadian standard ICES-005. Ce DEFR de la classe [A] est conforme à
la NMB-005 du Canada.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Electrical products must not be thrown out with domestic waste. They must be taken to a communal collecting point for environmentally
friendly disposal in accordance with local regulations. Contact your local authorities or stockist for advice on recycling. The packaging
material is recyclable. Dispose of the packaging in an environmentally friendly manner and make it available for the recyclable material
collection-service.
2
Peel off the release
paper from the back.
5 Connect the SA2-01
connector.
3
Distribute the rigid bars in the light box according to
proper spacing. Be careful not to damage lens, LEDs
and electronic components of the rigid bar.
6
Connect the main line
of rigid bar to the 24V
power supply.
3
Installation Guide
7
If the bar need to be
jointed, please arrange
it as the picture shows.