SwitchBot Contact Sensor Benutzerhandbuch Seite 8

Mount to a surface using screws
Remove the Battery Case from Contact Sensor. Mount the Battery Case to the target
surface using the screws provided. You don't need to peel the protective film off during
this process.
Install the Contact Sensor back to the Battery Case, that has been mounted to the target
surface.
Line up the Contact Sensor and the Magnet on the door or window and make sure the
Magnet is aligned with the bottom of the Contact Sensor.
Peel the protective film off Magnet and stick it to the surface near the Contact Sensor.
Make sure the gap between the sensor and the magnet is less than 30mm when the
door or window is closed.
Apply pressure to magnet for 60 seconds so it is firmly attached.
8