Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. Set a channel
Channel con guration
Select Channels
Channel 1
Channel 2
Channel 3
Please connect the probe(s)
before con guring the channel(s)
Next
Connect a probe to
The list of available
set a channel and tap
channel is displayed.
''Next''.
Tap the required
channel.
10. Set an output
Select Analog output
Output 1
Output 2
Output 3
Tap the output to set
Activate the output
corresponding to the
previously con gured
Set the output type and
channel.
high and low range
values then tap the back
arrow on the top left.
11. Maintenance
Please avoid any aggressive solvents. Please protect the transmitter and its probes from any cleaning
product containing formalin, that may be used for cleaning rooms or ducts.
12. Precautions for use
Please always use the device in accordance with its intended use and within parameters described in the
user manual in order not to compromise the protection ensured by the device.
Channel 2
PROBE 1
MODULE
Measure
SELECT MEASURE
Units
SELECT UNIT
1.000
Coef cient
Offset
Tap ''PROBE 1'' or
''MODULE''.
Parameters to set are
now available.
Analog
Output 2
4-20 mA
Output 1
Output 3
Output Type
100.0
Output 2
High Range (%RH)
0.0
Output 3
Output 3
Low Range (%RH)
Tap ''Next'' to dis-
taping
.
Channel 2
PROBE 1
PROBE 1
MODULE
Rel. Humidity
Measure
%RH
Units
1.000
Coef cient
0.00
0.00
Offset
Set the parameters
according to your
needs then tap the
back arrow on the top
left.
10:35 - 10/12/2021
27.7
Next
play measures.
Select Channel
Channel 1
Channel 2
Channel 3
Next
Channel two is con -
gured. Tap next to
con gure outputs.
Measurements
Channel 2
1
%RH
Werbung
