Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USE
This appliance is designed for professional use in commercial areas.
Connect the plug to the socket.
The hair dryer has 3 temperature levels and 2 air flow speeds, selectable via separate
switches. If the appliance is fitted with cold air button [C], you can operate it for
hairstyling.
Switch on the appliance using the On/Off switch [A] and select the required speed:
0 0 = OFF
I = mid air flow
II = strong air flow
Press the button to adjust the temperature [B] and select the level you prefer:
I = low temperature
II = mid temperature
III = high temperature
After use, using the On/Off switch [A] to switch off the appliance.
Do not pull the cord or the appliance to disconnect the power cord [G] from the
mains socket.
Store the appliance on a stable surface, paying attention not to wrap the
cord around the appliance.
Cold air button (Cold Shot) [C]
If the appliance is fitted with this button, you can operate it for hairstyling.
Holding the cold air button pressed, the dryer can be switched quickly to operate
with cold air and for hairstyling.
To return to the set temperature, simply release the button.
Using the air concentrator [H]
Thanks to the concentrator, the air is conveyed directly on the brush used for the
hairstyle.
Apply the concentrator and press it in towards the body of the hair dryer (Fig. 3a).
The concentrator can be retrieved by pulling it in the direction indicated by the arrow
b (Fig. 3b).
Wait until the nozzle has cooled down before removing it.
Using the air diffuser [I]
If the appliance has been equipped with the diffuser, this can be used to obtain a
volumising drying.
Apply the diffuser and press it in towards the body of the hair dryer (Fig. 4a).
The concentrator can be retrieved by pulling it in the direction indicated by the arrow
b (Fig. 4b).
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it,
the appliance must be analysed by the manufacturer or the relevant
technical assistance or in any case by a person with similar skills in
order to prevent any risk. The user must not disassemble the device
him/herself.
Remove the plug from the mains socket before cleaning the
appliance.
GENERAL CLEANING
Clean the appliance at least once a week.
To avoid all risk of electric shock, do not clean the appliance with water and do not
dip It into water.
Only wipe the appliance with a soft cloth, dampened if necessary.
Do not use solvents or abrasive detergents!
FILTER CLEANING
To maintain optimum performance of the device over time, you should clean the
filter regularly [E]:
• every day for intensive and continuous use
10
Werbung
