Eufab 17522 Bedienungsanleitung Seite 5

5.2 MOUNTING THE SMARTPHONE
Sticking on the magnetic metal plate:
If you use a protective cover for your mobile phone, remove it.
Clean the back of your mobile phone from dirt, dust and grease.
Read the care instructions in the manual for your mobile phone. of
your mobile phone. Remove the protective lm from the adhesive
coating of the magnetic metal plate, g. 2. Press the metal plate
onto the centre of the back of your mobile phone. of your mobile
phone.
Remove the protective lm from the metal plate, g. 3.
The magnetic metal plate is so thin that you can reattach most
protective covers.Translated with www.DeepL.com/Translator (free
version
Mounting the mobile phone holder:
Place the hard rubber clip on a slat of the ventilation grille in your
vehicle, g. 4.
Mounting the mobile phone on the holder:
Simply place the mobile phone with the magnetic metal metal plate
onto the mobile phone holder, g. 4.
Do not expose your mobile phone to direct air ow.
Close the corresponding ventilation ap. Otherwise,
overheating may occur in heating mode and condensa-
tion may form in air-conditioning mode. condensation
may occur.
Some protective covers may not achieve optimal
adhesion.
Remove the magnetic metal plate from your mobile device again.
Carefully lift the plate o the back of the mobile device with a knife
blade.
Do not use harsh cleaners or solvents to remove
adhesive residue. Refer to the care instructions for your
mobile device.
The adhesive may cause permanent discolouration of the
surface of the unit in the area of the of the adhesive may
occur.
Fig. 2:
Remove protective lm from
Remove adhesive coating
Fig 3:
Sticking a metal plate onto a
smartphone
Fig 4:
Mounting on ventilation nozzle
To remove the mobile phone holder, carefully pull it o the slat of the
ventilation grille. It may be necessary to hold the slat rmly to avoid
damaging the ventilation grille and its mechanics.
5.3 USE OF THE EMERGENCY HAMMER
Remove your smartphone from the mobile phone holder. Detach the
mobile phone holder from the ventilation grille.
Hold the mobile phone holder rmly in your hand. Hit the car
window rmly with the emergency hammer (position 3 in the
overview).
The silicone protection of the emergency hammer
cannot be removed. The carbide mandrel penetrates
the silicone protection when hitting the car window.
Laminated glass windscreens cannot be smashed with
an emergency hammer.
5.4 USING THE BELT CUTTER
Remove your smartphone from the mobile phone holder. Detach
the mobile phone holder from the ventilation grille.
Place the belt cutter (position 6 in the overview) of the mobile
phone holder of the mobile phone holder onto the edge of the seat
belt. Pull the belt tight with one hand and with the other hand pull
the belt cutter into the belt to cut it. Fig 6.
6. MAINTENANCE AND CARE
When used as intended, the mobile phone holder is
maintenance-free. maintenance-free.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
Dispose of the smartphone holder in accordance
with the laws and regulations applicable in your
country.
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Fig 5:
Emergency
hammer
Fig 6:
Belt cutter
info@eal-vertrieb.com
www.eal-vertrieb.com
5