Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
2
Fig. 14
1
3
7
6
5
4
Fig. 15
7.6 CLEANING THE TOOL
– The tool should be regulary cleaned. Especially the
tension wheel and the tension plug should be kept
clean. The easiest way to do this, is to use com-
pressed air and to blow out the dust (wear eye
protection). The tension wheel can also be cleaned
with the wire brush supplied.
12.07/WE
3
2
9
8
2
7.4 SETTING CLEARENCE BETWEEN TENSION
WHEEL AND TENSION PLUG
The tension wheel (14/1) and the tension plug
(14/2) must not touch (damage the teeth). If
the spacing is too great, the strap slips through before
the fi nal tension is reached.
– Disconnect tool from air supply.
– With Allen key (3 mm) adjust setting screw on lower
side of tool, so that the clearence between tension
wheel and tension plug is 0.2–0.4 mm
(.008"–.0016"). Turning clockwise increases the
clearence, turning counterclockwise decreases the
clearence.
– Turn setting screw in steps of
gap with an thickness gauge.
7.5 SETTING STRAP WIDTH
The tool can be used with different strap
widths (15–16 mm (
25 mm (1").
Modifi cation
– On front and rear side of the tool, remove cylinder
screw (15/1) and reverse strap guides (15/2) 180°,
mount cylinder screws again. Secure cylinder
screws (15/1) with Loctite 222.
– On lateral side of tool, remove cylinder screw (15/6)
and change strap guide (15/7):
– Strap guide 19 mm
1
– Strap guide 16 mm
– Strap guide 25 mm
– Secure cylinder screw (15/6) with Loctite 222.
– On lateral side of tool, remove two cylinder screws
(15/4) and uniformly remove support bar (15/5).
Change guide plate (15/9):
– Guide plate 19 mm Part No 1111.423.979
– Guide plate 16 mm Part No 1111.423.978
– Guide plate 25 mm Part No 1111.424.393
– Mount new guide plate with support bar. Observe
that the pin (15/3) lies in the notch of the new guide
plate.
– Secure cylinder screw (15/4) with Loctite 222.
ORGAPACK OR-P 400 HD
/
turns and check
1
8
/
"), 18–19 mm (
/
") or
5
3
8
4
Part No 1111.423.957
Part No 1111.423.956
Part No 1111.424.394
21
Werbung
