PNI Escort HP 62DE Benutzerhandbuch Seite 5

i. Low (Low Power) function is active
j. The received signal strength and the power of the transmitting signal
k. RX/TX: TX = transmit mode; RX=received mode
l. Frequency band selected
m. ASQ function available
n. Active setting of RF Gain level.
9. EMG key: briefly press this key to enter emergency mode 9/19; the EMG icon will blink
10. A/F-LCR key: to select AM or FM mode; the modulation you are setting will be displayed on the
screen. If you select a frequency that operates only in the FM band, the A/F-LCR key will activate the
Last Channel Recall (LCR)
11. Microphone: During the transmission, hold the microphone at a distance of 4 cm from the mouth
and speak using a normal tone of voice.
12. RFG Key: briefly press this key, on the screen "R 00" will show up; "00" will flash. Press the Q.UP/Q
DONW keys to select one of the 9 levels (00, 06, 12 ... 54); press this button again to confirm and exit
13. Lock key: It allows you to lock the keyboard, thus avoiding accidental use of the keys.
14. Q.UP-Q.DOWN keys: To skip 10 channels up (Q.UP) or 10 channels down (Q.DOWN)
15. Speaker
16. Dual Watch: This function allows the synchronization on two different channels at the same time.
Thanks to this function, you can monitor a second channel. When a signal on the second channel is
received, the conversation on the first channel is automatically interrupted and the receiver switches on
the second channel. The monitoring starts again 4 seconds after the signal end.
To activate this function, operate as follows:
- Select the desired channel through the channel selector
- Press the DW button
- Select the second channel
- Press the button DW again
- To cancel the function press again the DW button or the PTT button
17. SCAN key: you can automatically search for a busy channel
• Turn the squelch clockwise until the background noise is no longer heard.
• Press the "SCAN" button: the transceiver will scan automatically all the channels until a carrier is
being received.
• When it finds the carrier, it stops and starts again some seconds after the end of the communication
on the channel.
• When the radio is transmitting, the scan function is deactivated.
18. Key : when in the SQ mode short press this button, turn on the background light, short press this
button again, to turn off the light, long press this button will enter ASQ, in ASQ mode, short press the
button to turn on the background light and short press again will turn off the light.
19. Push to talk button (PTT): Its pressure activates the transmission. When it is released, the receiver
is activated.
20. Hole for wrist belt
21. Channel UP: To skip to the next channel. Keeping this button pressed, the "auto-repeat" function is
obtained.
22. Channel DOWN: To skip to the previous channel. Keeping his button pressed, the "auto-repeat"
function is obtained.
23. Contact for power adapter and external antenna. Push the button up to remove the adapter.
5
EN