DeLOCK 90406 Bedienungsanleitung Seite 3

English
Hardware Installation
1.
Turn off your PC and unplug the power cord.
2. Open the housing.
3. Remove the slot holder from the available PCI Express slot.
4. Insert the card straight and carefully into the free PCI Express slot, until it is
well seated.
5.
Use a screw to attach the card to the housing.
6.
Optionally, you can connect LEDs to the pin header.
7. Reattach the housing and connect the power cord to the AC adapter.
LED connector
1.
The two LED pin header "P0LED" and "P1LED" are used to connect LEDs,
which indicate the status of the HDD / SSD.
2. The two LED pin header "ERR" are used to connect LEDs, which display the
error message.
Status
normal
error
rebuilding
RAID setting
Please note:
If you install and activate a Raid system, make sure you have a full back up of
your present data.
Setup a RAID 1 set with existing data on a HDD / SSD. The HDD / SSD with
existing data needs to be connected to "P0 Primary", the second HDD / SSD
needs to be connected to "P1 2nd". Existing data on second HDD / SSD (P1) will
be lost during the process.
LED indicator
off
flashing
light
-3-