cecotec A3 Serie Bedienungsanleitung Seite 116

ENGLISH
Inserting the batteries
- Open the cover on the back of the remote control. Insert the batteries into the remote
control, respecting the "+" and "-" polarities. Refit the cover.
- The remote control is powered by two AAA LR03 1.5 V batteries. We recommend using only
alkaline batteries. Remove the batteries from the remote control if you are not going to
use it for a long time (more than one month). Used batteries must be disposed of safely.
Deposit them in specially designated collection containers to protect the environment.
Orientation
Point the remote control at the infrared sensor on the front of the TV at an angle of 30° so that
it can receive the transmitted information. The remote control has a range of 6 meters.
5. TROUBLESHOOTING
Before contacting the after-sales service, perform the following basic checks.
Problems
There is no
electricity.
There is no image
or sound.
There are no
DTT HD channels
or the image is
distorted.
116
TV LED A3 SERIES ALH30032 / ALH30032S
Possible causes
The plug is disconnected.
The power socket is
disconnected from the
mains.
The image settings are
incorrectly adjusted.
There is no audio.
Reception of digital
terrestrial television
channels (DTT) is only
possible in areas with
coverage.
Checks the proximity of a
transmitter.
Check the quality and
strength of the receiving
signal.
Possible solutions
Make sure the power cable is properly
plugged into a power outlet.
Try connecting the plug to different
power outlets to check.
Check the brightness and contrast
settings of the image.
Check that Mute mode has not been
activated.
Check that the antenna cable is well
connected to the TV.
Reset to factory settings.
Have a professional check your
installation.