Schluter Systems LIPROTEC-EBZS Kurzanleitung Seite 36

Assigning Bluetooth mesh receivers to a different group
If a Bluetooth mesh receiver has already been added to a
group, it can be assigned directly to another group. This au-
tomatically removes the Bluetooth mesh receiver from its pre-
vious group.
1. Disconnect the mains power supply to the Bluetooth mesh
receiver that you want to add to a group. To do this, pull
the power supply unit out of the mains socket.
2. Reconnect this Bluetooth mesh receiver to the mains sup-
ply (plug it into the socket).
3. Within 20 s: Press the
control at the same time.
4. Press one of the buttons 1–4. This button is the number of
the group to which the Bluetooth mesh receiver is added.
> All LED modules connected to the Bluetooth mesh
receiver flash briefly three times. The Bluetooth mesh
receiver has been added to the selected group. The
Bluetooth mesh receiver is simultaneously removed
from the old group.
Managing groups using Schlüter
CONTROL
Schlüter -LED-ZONES-CONTROL enables you to add Blue-
®
tooth mesh receivers to groups without having to disconnect
them from the power supply.
36
and + buttons on the remote
-LED-ZONES-
®