Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Use the special applicator to apply three parallel beads of glue, approx. 3 mm thick, on
the four feet, see Fig. 4, then position the solar panel on the clean roof surface and
press down firmly. Allow the glue to set for at least 24 hours (high humidity levels and
low temperatures will extend the time requirement) before moving the vehicle.
FIG. 4
To be able to obtain the strongest power generation, ensure that the solar panel position
is not shadowed by existing structures. When the solar panel is installed in line with the
travelling direction, the spoiler (see Fig. 5a) should be installed, to reduce wind noise
and prevent any objects becoming caught in it. To remove the spoiler, check Fig.5b.
If the solar panel is installed transversally to the travelling direction, the spoiler doesn't
have to be fitted.
The spoiler should only be installed after the glue has set.
1
2
FIG. 5a
FIG. 5b
4
Werbung
