Philips Azur Excel Plus HI569 Bedienungsanleitung Seite 7

setting after ironing at a high temperature, do
not recommence ironing before the amber pilot
light (H) first has come on and then has gone
out again.
Corded ironing
15
- Set the 3-positions switch to position ª
(fig. 15).
- Take the iron (with power unit) from the stand
(fig. 16).
- Either place iron (with power unit) on heel rest
or on the stand when you interrupt ironing.
Cordless ironing
17
- Set the 3-positions switch in position ∫
(fig. 17).
- Take the iron (without power unit) from the
stand (fig. 18).
- Always replace the iron on the stand when you
interrupt ironing.
• (Types HI 565/66 only) The user may continue
ironing as long as there is no lamp indication.
However, if the pilot light (H) starts to flash, it
indicates that the iron has cooled down below
the set temperature. For optimal ironing
performance the iron should be replaced to the
stand for heating up to the set temperature. As
soon as the soleplate has regained the set
temperature, the pilot light (H) wil go out.
• When cordless steam-ironing for a
considerable time and when applying a number
of "shots of steam" or "turbo steam" the
soleplate might cool down more than required.
For that reason we advise you to always use
the iron in the corded mode if you intend to
16
18
steam iron for a
considerable time.
Spraying T
At any temperature by
pushing on the spray
button T (C) a couple of
times the laundry can be
damped down (fig. 19).
Ensure that there is enough water in the water
reservoir.
Steam-ironing
• As indicated on the temperature control (A) and
the table, steam-ironing is only possible at
higher ironing temperatures:
2 or 3 for moderate steam
3 for maximum steam.
• With conventional steam irons, water may leak
from the soleplate if a too low temperature has
been selected. This will then cause stains.
However, your new steam iron features "Drip
Stop" steam shut-off:
the iron will automatically stop steaming at too
low temperatures.
When this happens, you can hear "Click".
Set the temperature control (A) to the advised
position.
Steaming will recommence as soon as the
appropriate (higher) temperature has been
reached.
• Ensure that there is enough water in the water
reservoir.
- Put the iron on its
stand.
- Set the temperature
control (A) at the
required position
within the "steam
area" (2 or 3)
(fig. 20).
- Insert the mains plug
into the wall socket.
- After the amber
temperature pilot light
(H) first has gone out
and has come on
again, you may start
ironing.
- Slide the steam
control (B) to the required position (fig. 21).
7
19
20
21