Navitel R480 2K Bedienungsanleitung Seite 22

Installation of DVR
1. Put the microSD card into the DVR. Use a high-speed SD card (ClassU3 or above); capacity should
be within 8-256 GB.
• To avoid malfunctions of the DVR and / or SD-card, don't insert and remove SD-card
during DVR operation.
• Before using a microSD card, please format it inside the DVR to avoid data errors. For
formatting the SD-card in Menu mode select Format SD-card and confirm it.
2. Stick the electrostatic film on the windshield and fix the DVR over it with the mount.
3. Connect the car charger to the cigarette lighter socket.
4. Connect the car charger to the DVR.
5. Adjust the camera position.
6. Turn the power on; check whether the device is installed correctly. If the device is installed correctly,
the indicator will glow.
Rear camera installation
Install the camera inside the car on the rear window with a sticker, put the wire through the cabin,
connect the wire to the rear camera port.
Note: It is strongly recommended that works on installing the camera should be done by qualified
personnel with the necessary skills. Cable routing may require special tools or attachments. Make
sure these works are safe.
The camera is not waterproof.
STARVIS and are trademarks of Sony Corporation.
NAVITEL R480 2K | 21
EN