Motion Computing Mobile Installationshandbuch Seite 8

Some devices, such as mice do not require a PIN code to be
entered by the user.
Connect the Devices
After pairing, some Bluetooth software applications require an
additional step to manually connect certain devices, such as a
GPS receiver. After that initial connection, some devices may
disconnect when they go into power saving mode. Most
devices will automatically reconnect when they become active
again.
Installing the Motion Wireless Mobile Keyboard
Hardware Requirements:

Motion Computing® M1400 Tablet PC (internal Bluetooth radio)
-or-

Motion Computing M1200 or M1300 Tablet PC with a Bluetooth
PC card installed
1. Install the Batteries
Install three AA batteries in the slot in the bottom of the
keyboard. Make sure they are inserted in the correct direction.
2. Power on the Keyboard
Press the keyboard power/reset button
the upper-right corner of the keyboard, to power on the
keyboard. The blue status LED on the keyboard should flash a
few times. If not, check the batteries; then press the
power/reset button again to power on the keyboard.
3. Start Your Bluetooth Application
Using your pen, single tap the Bluetooth Devices icon in the
system tray. Alternatively, at the Start Menu, select Control
2
,
which is found on