USE
Read through and follow the setup
guide or use the default functions.
Note, the clock is set through the setup
process.
To get started, open the battery com-
partment located on the back and insert
4pcs AA batteries. (The camera can also
be powered from a 5V adapter through
USB.
TROUBLESHOOTING:
Problem
The camera works at day, but not at
night.
The camera will not turn on.
No photos or videos have been re-
corded to the TF/SD card.
If powered by an adapter, it is recom-
mended to remove the batteries.
Insert the memory card.
The included strap can be used to
mount the camera on a tree or pole.
When the camera is set up and ready
for use, slide the ON/OFF switch to the
ON position and the indicator will start
to flash.
The camera will then enter the PIR
(Passive infrared detection) mode and
record images and / or videos based on
the configuration or as the default re-
cord 3 photos, 10 s. of video and add the
time and date to the recorded media.
Solution
Check and replace the battery as it might
be attributed to low power.
Make sure the batteries have power and
are positioned according to the polarity.
1. Make sure the card is formatted to
FAT32.
2. Replace batteries
3. Turn the camera on and off and
ensure it flashes 5 times before entering
PIR mode.
4. confirm that the subject is within 15 m
of the camera.
3
EN