Technical Data - Schou Ranger 90877 Gebrauchsanweisung

GAME TRAIL CAMERA
INTRODUCTION
To get the most out of your new product, please read this manual before use. Please also
save the manual in case you need to refer to it at a later date.

TECHNICAL DATA

Size:
Each set includes camera, tree strap
and card reader
Image sensor:
Photo resolution:
Video resolution:
Trigger time:
Work mode: Photo, video, photo+video
PIR distance:
PIR angle:
Lens:
Memory:
Uses 4 x AA batteries (not included)
IP 54
Stand-by Time:
Temperature:
SETUP
To set up the camera, make sure you
use a FAT32 formatted memory card,
otherwise, the camera will not be able
to write to it.
Set the date, time, and operation
On your computer, open notepad or a
similar program. Type in the current
time in the format shown below:
YYYY-MM-DD-HH:MM:SS
Example:
2021-01-25-12:12:12
11 x 9,2 x 5,5 cm
1.3MP colour CMOS
20MP
FDH 1920x1080P
25FPS
0.8S
15 m
60 degrees
Wide 52 degree
Max Micro SD 32GB
8 Months
-10 ~ + 70 o C
2
Configuring the camera is done in the
same file, just add a "-" after the date/
time function and then choose from
the options below.
1. Number decides the mode of the
camera. 1=photo, 2 = video, or 3 = video
and photo.
2. Number of photos to record. A Num-
ber from 1-5 will make sure it records
that number of photos.
3. Number of seconds of video record-
ed: 1=5 s., 2=10 s., 3=20 s., and 4=30 s.
4. Letter will decide whether to display
the date on any recorded media.
and N=None
The default configuration is 332Y.
When everything has been set and it is
formatted like below:
2021-01-25-12:12:12-332Y
save the file as "time.txt" and transfer it
to the card.
If the camera is on, it will only accept
the new settings when it has been pow-
ered OFF and then ON again.
Y=Yes