ATA B4728/31 Bedienungsanleitung Seite 34

16. Connect the wires marked 8 and 23 to the male faston terminals of the drain switch (5) supplied
with the kit; connect the wires no. 7 and 24 to the male faston of the drain warning lamp on the
machine control panel (the second indicator light from the left when looking at the dishwasher
frontally). Refer to the wiring diagram. Make sure that the warning lamp does not come out of its
seat when the wires are being connected. If it does, return it to its position.
17. Return the control panel to its seat, taking care that its side edges slide into the appropriate steel
guides on the dishwasher back section. Then, fasten the panel again using the two screws.
18. Finally, you need to refit the dishwasher lower front panel and back panel (after having
repositioned the detergent dispenser, if fitted, on its bracket). The drain pump kit installation is
now complete.
33