ATA B4728/31 Bedienungsanleitung Seite 29

4. Unscrew the ring nut that fixes the plastic drain fitting to the brass drain fixed to the tank and
remove the fitting together with the drain pipe connected to it and its black gasket. Drain pipe,
gasket and fitting must not be re-used.
5. Insert the drain pump complete with bracket and drain hose (1) from the front side of the
dishwasher, sliding the drain hose along the entire length of the dishwasher until it comes out
from the rear side, and placing the pump on the base of the dishwasher next to the drain. The
siphon curve (4) supplied with the kit must be suitably applied to the drain pipe according to the
position of the drain, taking into account that the height of the drain in relation to the pump cannot
exceed about 80 centimetres.
6. Align the two bracket mounting holes of the drain pump with the two rivets on the machine base.
Then, fix the bracket to the base using the supplied screws and washers.
28