Electrolux LFG615X Benutzerinformation Seite 57

1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Turn the filter counterclockwise (1) and
then pull (2).
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
The appliance does not absorb
enough vapours.
The display shows .
The display shows .
8. ENVIRONMENTAL CONCERNS
Recycle materials with the symbol
packaging in relevant containers to recycle it.
Help protect the environment and human
health by recycling waste of electrical and
1
2
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
The lamp is defective.
The motor speed is not adequate to
the appearing vapours.
The filter alarm is on. The grease fil‐
ter must be cleaned.
The filter alarm is on. The charcoal
filter must be replaced or cleaned.
. Put the
To mount the filters back follow the steps in
reverse order.
In any case, it is necessary to replace the
filters at least every four months.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp. Refer to the
"Care and Cleaning" chapter.
Change the speed of the motor.
Refer to the filter alarm in "Care and
cleaning" chapter.
Refer to the filter alarm in "Care and
cleaning" chapter.
electronic appliances. Do not dispose of
appliances marked with the symbol
the household waste. Return the product to
your local recycling facility or contact your
municipal office.
57
with