Installation And Connection - Bartscher A100205 Bedienungsanleitung

5.2 Installation and connection

Installation
•
Unpack the device and remove the packing materials.
•
Attach the adjustable feet to the device and adjust their height to ensure that the
device is stable.
•
Locate the device on a level surface, sufficiently strong to hold the device, and heat
resistant.
•
Never locate the device on inflammable surfaces, or in direct proximity of walls,
partitions or kitchen furniture unless they are made of non- inflammable materials
or covered with thermal insulation materials. Comply with fire safety regulations.
•
Do not locate the device near heat sources such as grilles/barbecues, fat fryers,
etc., or near any devices where the fat may splash.
•
To ensure the device's safe operation, maintain a distance of 10 cm from the sides
of the device, 30 cm at the front and rear, and 30 cm above (e.g. in relation to a wall-
mounted shelf).
•
Ensure adequate ventilation of the device location.
•
Do not locate the device near any air-condition vents.
•
Do not place any objects on top of the device while in use. It may cause a fire hazard
and risk of injury. It may also cause damage to the device.
•
Place the device indoors at the temperature 21 ° C - 29 ° C to ensure safe operation and
compliance with regulations.
•
Unplug and cool down the device before installation and location. Non-conformity may
result in injury.
Electric power supply
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label). Connect the device only in case of compliance!
The device must only be connected to a properly installed single socket with
protective contact.
Never remove the power cable by pulling the cable itself; always grab the plug
housing.
- 23 -