TOPRO TAURUS H Bedienungsanleitung Seite 10

EN
Locking the swing (directional block), TOPRO TAURUS H Premium
Locking the swing can be done with an index pin A on both wheels. Ensure the mounting bracket for the foot
brake is pointing backwards.
This is how the index pin works:
Locking: Twist the upper part of the index pin B so that it fits into the track of the lower part C. By doing this
the pin D will slide out and lock.
Releasing: Pull the upper part of the index pin B up and turn it 90 degrees. NB! Make sure it stays in the upper track.
It will then lock in the upper position. The pin D slides in and the index pin is unlocked.
Please note: If there is no need to lock the swing but there is a risk that the user may unintentionally release the index
pin, we recommend to remove it. This is done by screwing it out with an adjustable spanner.
Transport
The walker can be transported either in vertical or in horizontal position. The walker should be set in the lowest
height position, to save space and ease the handling. Ensure that the foot brakes are on. Be careful when loading
the walker into a vehicle, giving attention to securing of the item.
Storage
The walker should be stored inside and in an upright position.
Material // Recycling
The walker is made of plastic coated aluminium pipe, plastic couplings and material of plastic and polyester.
The forearm cushion is of polyurethane. Most parts can be recycled. Dispose the walker according to the applicable
regulations in your country. For information, please contact your public authorities.
Cleaning
The walker can be steamed, hosed and washed with normal household detergents. Do not use scrub detergents,
steam- or high-pressure cleaners.
Disinfection
Disinfection must only be carried out by authorized personnel and by wearing sufficient protective equipment.
The surface must be cleaned with a disinfection that contains 70–80 % ethanol. We advise against disinfection that
contains chlorine and phenol. The manufacturer cannot be held responsible for any damage or wounds that might occur
by the use of harmful disinfection or disinfection carried out by unauthorized personnel.
Inspection // Maintenance // Re-use
The wheel bearings are sealed and maintenance-free. The parts do not need to be lubricated. It is recommended that
general inspection and maintenance is carried out and that the items below are checked frequently (how frequent
is determined by how and how often the walker is used): tubes, frame and screws, handles and forearm supports,
brakes, wheels and accessories. This also applies when the walker is to be prepared for re-use. Please see detailed
instructions in this user manual about maintenance of the brakes and cleaning and disinfection of the walker.
If the product does not work properly
1 = Possible reason
Brakes
1 Worn out / defect wheel
1 Not braking effectively
1 Worn out / defect brake mechanism on wheel
1 Worn out / defect brake handle
1 Worn out / damaged brake wire
Height adjustment
1 The gas spring is worn out or damaged
1 The height adjustment handle is maladjusted
TAURUS H
2 = Action
2 Change the complete wheel
2 Adjust the brake wires
2 Change the entire back wheel section
2 Change the complete brake handle
2 Change the brake wire
2 Change the gas spring
2 Adjust the handle
www.topro.no
EN
9
9