RadioMaster TX16S MKII Schnellstartanleitung Seite 4

Power Requirements.
The TX16S MKII has built in USB-C charging for 3.7v Lithium cells. The Charging circuit is designed for
2x 3.7v Li-ion 18650 unprotected cells or 2x 3.7v Li-poly cells (2s 7.4v LiPO pack) only with a nominal
cell voltage of 3.7v and maximum charge capacity of 4.2v.
Model and protocol selection (multi-protocol module)
A wide variety of modules is available for TX16S MkII units with the 4-in-1 module. To find out whether a
certain protocol would work with your radio, please visit: https://www.multi-module.org/
Please note that current protocols may be updated, and new protocols added, without prior notice.
Press and hold the MDL button and scroll to the MODEL SETUP page. Under internal RF, set the Mode to
MULTI and select the RF Protocol/ sub protocol as desired. Once the protocol is selected, the corresponding
RF chip will be activated.
Note:
-The Bind button starts the bind process, if a compatible receiver is in bind mode within range, it will bind to
your receiver.
-Range mode cuts the RF output by a factor of 30, allowing for easy range testing.
Model and protocol selection (ELRS)
Bind method
1.Turn off the radio.
2.Cycle power to the receiver 3 times, the receiver LED will start blinking, indicating it's in bind mode.
3.Turn on the radio, enter the ExpressLRS LUA, and select Bind.
4.The receiver LED will now stay illuminated, signaling a successful bind process.
Support.
Warranty and Repairs.
Please retain your proof of purchase and contact the retailer you purchased your TX16S MKII from,
should you experience any problems with your radio hardware. Warranty is valid for one year from the
date of purchase.
3