Operation; Device Operation - probst KIG-I-USA Betriebsanleitung

Operation

5 Operation
5.1

Device operation

•
Connect the device to the lifting gear (forklift). The lifting gear must be adapted to the required load-bearing
capacity (WLL) of the device (KIG)!
•
Insert the device from above into the gripping material (shaft cone) until the rectangular tube rests [completely],
making sure that no step irons are in the way!
•
As soon as the rectangular tube rests on the gripping material and the device (KIG) is unloaded, the automatic
changing device unlocks.
•
Lift the unit; it opens and the oscillating gripper jaws contact the load from the inside. The load can thus be lifted.
•
Carefully transport the load to its destination!
•
When lowering the load again, the unit must be lowered until the rectangular tube rests on the load and the unit
(KIG) is unloaded again.
•
The automatic changing device then locks automatically and the device can be extended upwards again.
57200106 13 / 17 GB