AEG L 73471 FL Benutzerinformation Seite 23

Problem
The spin phase does
not operate or the
washing cycle lasts
longer than usually.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The appliance fills
with water and drain
immediately.
The washing results
are not satisfactory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Service.
Possible solution
Make sure that the connection of the drain hose is cor-
rect.
Set the drain programme if you set a programme with-
out drain phase.
Set the drain programme if you set an option which
ends with water in the tub.
Set the spin programme.
Make sure that the drain filter is not clogged. Clean the
filter, if necessary. Refer to 'Care and cleaning'.
Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
Make sure that the couplings of the water hoses are
tight and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the cor-
rect quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in
the drum.
Make sure the levelling of the appliance is correct. Re-
fer to 'Installation'.
Make sure that the packaging and/or the transit bolts
are removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too
small.
Make sure that the drain hose is in the correct position.
The hose may be too low.
Increase the detergent quantity or use a different de-
tergent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
ENGLISH
23