Trust PREMIUM-LINE ZCO-900 Bedienungsanleitung Seite 8

EN
ZCO-900 CARBON MONOXIDE DETECTOR
3. DOWNLOAD APP
First download and install the Trust Smart Home Switch-In App from the Google Playstore or App store to connect the CO
detector to an ICS-2000 or Smart Bridge bridge.
4. CONNECT DETECTOR
A
In the App, select a room, press the + button and choose Trust Zigbee line/Carbon Monoxide detector and follow the
instructions. For manual set up of push-notifications go to the rules tab, press the +
button and select notification wizard.
5. MOUNT THE DETECTOR
A
Mount the bracket of the detector on a flat surface on the ceiling and secure it with the included screws.
1
B
Place the detector on the mounting bracket.
2
Secure the detector by twisting it on the bracket to lock it.
6. TEST MODE
Activate the test mode of the detector to check the operation by pressing the Test button. The LED will flash fast and the
detector will sound.
RESET DETECTOR AND ACTIVATE CONNECT MODE
Warning: This step will disconnect the detector from the Smart Bridge or the ICS-2000. To reset the detector press the
button in the hole at the side for approximately 5 sec with the included pin. The LED will flash 6x to confirm the reset.
Activate connect mode: After
resetting the detector you can activate the connect mode by
pressing the button in the hole on the side for approx. 2 sec. The LED will flash fast for 1 minute to indicate the connection
mode.
REPLACE BATTERY
A
Open the battery compartment by removing the detector from the bracket.
B
Remove the empty battery and insert a new 3V CR123A lithium battery in the compartment. Note the positive and
negative polarity.
C
Lock the detector back on the bracket. Test if the battery is placed correctly by activating the test mode. (See step 6).
DISCLAIMER
Trust cannot be held responsible or liable for injuries caused by a carbon monoxide leak.
8