Vasner Citara Plus Serie Montage- & Bedienungsanleitung Seite 16

VASNER
10 cm
3. The heater may only be installed on the wall or the ceiling using the
bracket supplied.
4. When operating the heater without using a thermostat, ensure that the
room does not overheat. This is particularly important in small rooms
where there may be children or pets.
5. If you use the heater with a thermostat, ensure that the thermostat is
suitable for the corresponding wattage.
6. The heater may only be directly connected to the power supply by an
authorised person (electrician).
7. Ensure that no water pipes or electricity cables within the wall or
ceiling are damaged when drilling.
Installing the heating panel
1. On the rear of the heater, remove the wall bracket, which is fitted when
delivered so you can see how to correctly fit the heater to the bracket.
2. Position the bracket on the wall or ceiling to find the right position for
the heater. As soon as the bracket is correctly positioned, use a pencil
or marker to mark the 4 drill holes in the corners of the bracket on the
wall or ceiling. The bracket fitted in the corner drill holes must always be
flush to the wall
16
10 cm
10 cm
GB
10 cm
50 cm