Nordmende RTF245WHA+ Bedienungsanleitung Seite 5

Installation and Switching On The Appliance
• Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system at your home.
• This appliance is connecting to 220-240V and 50 Hz.
• You can offer help from the service to install and switching on the appliance.
• If the socket does not match the freezer plug, replace the socket with a suitable one
(at least 16 A). Insert the plug into a socket with an efficient ground connection. If the
socket has no ground contact or the plug does not match, we suggest you to call an
authorised electrician for assistance.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight. Do not use the
appliance in open air and shall not be exposed to the rain.
• Place the freezer far from heat sources and in a well-ventilated
position. The freezer should be at least 50 cm from radiators,
gas or coal stoves and 5 cm far from electrical stoves. Keep
the top free for at least 15 cm.
• Fit the plastic wall spacers to the condenser at the back of the
freezer in order to prevent leaning to the wall for good
performance.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another freezer, observe a
minimum distance of 2 cm to prevent condensation.
• The appliance must be stand firmly and level on the floor use
the two front levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap; the inside
of the appliance with sodium bicarbonate dissolved in lukewarm
water. After drying replace all the accessories.
• The appliance is not intended for use by people (including children) with reduced
physical,sensor yor mental capabilities , or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a preson responsible for their safety. Children should be supervised to ensure that
they don't play with the appliance.
• If the supply cord is damaged it must be replaced by the manufacturer or service
agent or appointed person.
Before Switching On
• Wait 3 hours before plugging the appliance in to the main power
to ensure proper performance.
• There can be an odour when you first switch on the appliance. It
will disappear after the appliance starts to cool.
EN - 4 -