Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PART 5.
Transportation and Changing of Installation Position
• The original packages and foamed polystyrene (PS) can be concealed if required.
• In transportation the appliance should be tied with a wide stripe or a strong rope.
The rules written on the corrugated box must be applied while transporting.
• Before transporting or changing old installation
position, all the moving objects (i.e. shelves,
crisper...) should be taken out or fixed with
bands in order to prevent the shake.
Changing of Door Opening Direction
In case you need to change door-opening direction, please consult the domestic after
sales service.
BEFORE CALLING YOUR AFTER SALES SERVICE
PART 6.
If your freezer is not working properly, it may be a minor problem, therefore check the
following, before calling an electrician to save time and money.
What to do if your appliance does not operate;
Check that;
• There is no power, (GREEN lamp is off)
• The general switch in your home is disconnected ,
• The thermostat setting is on « 0 » position ,
• The socket is not sufficient. To check this, plug in another appliance that you know
which is working into the same socket.
What to do if your appliance performs poorly; (Red lamp is on)
Check that;
• You have not overloaded the appliance ,
• The freezer thermostat settings is "1" position (if so set the thermostat dial suitable
value)
• The doors are closed perfectly ,
• There is no dust on the condenser ,
• There is enough place at the rear and side walls.
TRANSPORTATION AND CHANGING OF
INSTALLATION POSITION
EN - 10 -
(For some models)
Werbung
